Enterasys 2H252-25R Installation & User Manual page 32

Installing the Device
Figure 3-2 Attaching the Strain-Relief Bracket
Rack Mounting the 2H252-25R
Proceed as follows to install the 2H252-25R into a 19-inch rack:
1. There are several mounting holes in the rackmount brackets and the bottom of the chassis so that
each mounting bracket may be adjusted forward or backward to mount the device further into,
or out of the rack, depending on the installation requirements. Position the rackmount brackets
over the appropriate holes.
CAUTION: Do not attempt to attach the rackmount brackets with screws other than the
6-32 x 1/4-inch flathead
damage the unit.
2. Locate the four 6-32 x 1/4-inch flathead screws in the rackmount kit. Use these screws to attach
the rackmount brackets to the bottom of the 2H252-25R as shown in
3-6 Installation
screws shipped with the 2H252-25R. Use of longer screws may
Figure 3-3.