Epson C82378 Administrator's Manual page 43

IPX routing protocol "NLSP"
It is possible to set the IPX routing protocols "NLSP" from
NetWare 4.1x or later; however, the network adapter does not
support NLSP. RIP/SAP controls the communication.
You can select the routing protocol from a) NLSP with RIP/
SAP Compatibility or b) RIP/SAP Only. If you remove the
bind of RIP or SAP when NLSP with RIP/SAP Compatibility
is specified, the network adapter is not able to communicate
with the file server and NDS. (See "Protocols" and "Bindings"
in NetWare's INETCFG utility.)
Time required to recognize the network adapter
It takes up to two minutes for the NetWare server to recognize
the network adapter after turning on the printer. During this
start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server
and IPX router on the same network. If more than one frame
type is used on the same network, bind all the frame types to
the NetWare servers and IPX routers.
For NetWare 5
The IPX protocol must be installed (bound) to the NetWare 5
server.
About modes
If the mode you have logged in is different from the mode you
set for the network adapter, a message appears when you try
to configure the network adapter for NetWare. If you do not
want to change the current settings, click Cancel and log in
again in the same mode as you set for the network adapter.
Settings for NetWare
4-4