Table of Contents
Advertisement
Chapter 2
Easy Setup Configuration
You can use EpsonNet WinAssist Easy Setup to configure the
printer for use on a network using either the TCP/IP protocol or
the NetBEUI protocol.
If EpsonNet WinAssist is installed on your computer, you can
access EpsonNet WinAssist Easy Setup from the Start menu. If
EpsonNet WinAssist is not installed on your computer, you can
access EpsonNet WinAssist Easy Setup directly from the CD-
ROM. Refer to the appropriate section below.
Note:
❏ Make sure that the TCP/IP protocol is installed in your computer.
To print using NetBEUI, make sure that the NetBEUI protocol is
installed on your computer. See Appendix A, "Installing
Protocols," to install the necessary protocols.
❏ Before proceeding to the appropriate section below, you must set the
IP address for the network adapter or log on to the NetWare server.
Easy Setup Configuration
2-1
Advertisement
Table of Contents
