Epson C82378 Administrator's Manual page 35

2. The default IP address of the network adapter is
"192.168.192.168". Check that the network adapter is
reachable by "pinging" it from the command line:
ping 192.168.192.168
3. If the network adapter is reachable, you should see results
something like the following (the exact form of the message
depends on your operating system, and the time may vary):
64 bytes from 192:168:192:168:icmp_seq=0. Time=34.ms
4. If the network adapter is unreachable, you may see something
like:
PING 192:168:192:168:56 data bytes
until you press Ctrl-C, when you may see something like:
192:168:192:168 PING Statistics
3 packets transmitted, 0 packets received,
100% packet loss
Again, the exact wording of the message you see may differ
from this, depending on your operating system. If you cannot
"ping" the network adapter, check the following:
❏ The address is correct in the ping command.
❏ The Ethernet connection to the network adapter and to
the host has been made correctly, and all hubs, routers,
etc. are switched on.
❏ The network adapter is operating normally (red light off,
green or orange light on).
Setting the IP Address
3-7