Select The Utc/Local Hardware Clock Setting; Timezone Configuraiton - Enterasys 2S4082-25-SYS Hardware Installation Manual

The NAC Controller Initialization Procedure
Figure 6-19
If your system hardware clock is set to local time, go to Step
is set to UTC, go to Step
14. If your system hardware clock is set to local, the timezone configuration screen displays as
displayed in Figure
Figure 6-20
15. A screen appears allowing you to enable an SNMP daemon. To monitor the NAC Controller
using SNMP click on Yes as displayed in Figure
click on No, the display performs some processing and returns to the system prompt.
6-14 Initializing the NAC Controller

Select the UTC/Local Hardware Clock Setting

15.
6‐20. Select the desired timezone and click OK to proceed.

Timezone Configuraiton

14. If your system hardware clock
6‐21 to proceed, otherwise click on No. If you