Configuration Guidelines; Lanview Leds; Power Supply Leds; Power Supply (Ps) Led Status Definitions - Enterasys 2S4082-25-SYS Hardware Installation Manual

Configuration Guidelines

Configuration Guidelines
The NAC Controller PEPs for the Enterasys NAC Controller are equipped with a firmware‐based
management tool, which provides the capability to configure the NAC Controller PEP and access
chassis, power supply, and fan information.

LANVIEW LEDs

The following sections describe the LANVIEW LED indications for the following:
• Enterasys NAC Controller power supplies
• Enterasys NAC Controller fans

Power Supply LEDs

There are two power supply LEDs on the front panel of the chassis, one for each power supply.
Refer to Figure 2‐1 for the location of the power supply LEDs. Table
states of the power supply LEDs under different conditions.
Figure 2-1
1 PS1 LED
Table 2-1 Power Supply (PS) LED Status Definitions
Condition
1
2
3
2-2 Installation Requirements and Guidelines

Power Supply LEDs

2 PS2 LED
PS1 PS2
ON ON
ON OFF
OFF ON
2‐1 describes the different
PS1 LED PS2 LED
Green
Green
Red Green
Green
Red