The 2S4082-25 Nac Controller Pep - Enterasys 2S4082-25-SYS Hardware Installation Manual

Overview

The 2S4082-25 NAC Controller PEP

The 2S4082‐25 NAC Controller PEP has 24, 10BASE‐T/100BASE‐TX/1000BASE‐T compliant ports
by means of 24 fixed front‐panel RJ45 connectors on the PEP and 2, Mini‐GBIC Gigabit ports.
The 2S4082‐25 is installed in the Enterasys Matrix N1 chassis.
Figure 1-1
1 OFFLINE/RESET switch
2 RJ45 COM (Console port)
3 CPU LED
4 MGMT LED
5 GROUP SELECT button
6 GROUP STATUS LEDs
1-4 Introduction
2S4082-25 NAC Controller PEP
7 GROUP SELECT LEDs
8 Mini-GBIC Gigabit port slots (2)
9 Gigabit port link/activity LEDs
10 USB port
11 10/100 Ethernet port link LED
12 10/100 Ethernet port (see Note below)
Note: The 10/100 Ethernet port is for management purposes only. If you want network
connectivity, you need to connect to one of the ports with 10/100/1000 Mbps ports as
shown in Figure 1-1.
13 VGA port
14 RS232 serial COM port
15 CPU power LED
16 CPU reset button
17 Hard drive activity LED
18 10/100 Ethernet port activity LED
19 Ports (1-24), 10/100/1000 Mbps, via 24
RJ45s