Setting Up The Enterasys Matrix N1 Chassis; Order Of Installation; Installing The Chassis On A Flat Surface; Contents Of The 2S4082-25-Sys And 7S4280-19-Sys 7C111 Carton - Enterasys 2S4082-25-SYS Hardware Installation Manual

Nac controller
Table of Contents

Advertisement

Setting Up the Enterasys Matrix N1 Chassis

Table 3-1 Contents of the 2S4082-25-SYS and 7S4280-19-SYS 7C111 Carton
Item
2S4082-25-SYS or 7S4280-19-SYS Standalone Series 7C111
2S4082-25 or 7S4280-19 NAC Controller PEP
Rubber Feet
Power Cords
ESD Wrist Strap
Manual URL Location Card
Patents Sheet
Hardware Installation Guide (this manual)
4.
Inspect the Enterasys Matrix N1 Chassis for any signs of physical damage. Contact 
Enterasys Networks if it is damaged. Refer to "Getting Help" on page xviii for details.

Setting Up the Enterasys Matrix N1 Chassis

The following sections describe the procedures that must be followed to complete the installation 
of the Enterasys Matrix N1 Chassis.

Order of Installation

Once a suitable site has been chosen, the Enterasys Matrix N1 Chassis can be installed as a 
freestanding or rackmounted unit.
It is recommended that the Enterasys Matrix N1 Chassis installation proceed in the following 
order:
1.
Install the rubber feet (for standalone installation). For details, refer to "Installing the Rubber 
Feet" on page 3.
2.
Mount the chassis to a 48.26‐centimeter (19‐inch) rack or other secure location. For details, 
refer to "Installing the Chassis into a Rack" on page 3.
3.
Attach the Electrostatic Discharge wrist strap. For details, refer to "Attaching the Electrostatic 
Discharge Wrist Strap" on page 4.
If you are installing the Enterasys Matrix N1 Chassis as a freestanding device, start with 
"Installing the Rubber Feet" on page 3. To install the chassis in a rack, rubber feet are not needed.

Installing the Chassis on a Flat Surface

3-2 Enterasys Matrix N1 Chassis Setup
Note: Before installing the rubber feet, place the chassis on its back on a sturdy flat surface to have
access to the bottom of the chassis.
Caution: Read
Chapter 2
guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea
cumplir con todos los requisitos de instalación.
before completing the following procedure to ensure that all installation
Quantity
1
1
4 (self-adhesive)
2
1
1
1
1
Chapter 2
para y asegúrese de

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

7s4280-19-sys

Table of Contents