Memory Locations And Replacement Procedures; Location Of Memory Modules; Mode Switch Location On The Nac Controller Pep (2S4082-25 Shown - Enterasys 2S4082-25-SYS Hardware Installation Manual

Memory Locations and Replacement Procedures

module names, are reset to the factory default settings. Once the module resets, you can either
use the factory default settings or reenter your own parameters.
• Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Figure B-1
1 Mode switch bank
Memory Locations and Replacement Procedures
In the event that the Dual In‐Line Memory Module (DIMM) or DRAM Single In‐line Memory
Module (SIMM) needs to be replaced, the following sections describe how to access, locate, and
replace these memory modules. If you have questions concerning the replacement of either
memory module, refer to "Getting Help" on page xviii for details on how to contact
Enterasys Networks.

Location of Memory Modules

The location on the main board of the DRAM SIMM and DIMM for both the 2S4082‐25 and the
7S4280‐19 are the same. Figure
main board of the 2S4082‐25.
B-2 Mode Switch Bank Settings and Optional Installations
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.

Mode Switch Location on the NAC Controller PEP (2S4082-25 shown)

B‐2 shows the locations of the DRAM SIMM and DIMM on the