ZyXEL Communications Prestige 2602HWL-D3A Support Manual page 99

not knowing what your MAC address is, please enter a command "ipconfig /all" after DOS prompt to get the
MAC (physical) address of your wireless client.
If you use SMT management, the MAC Address Filter configuration are as shown below.
Enter the MAC Addresses of wireless cards in the filter set to allow or deny association from these cards.
Active= Yes
Filter Action= Allowed Association
------------------------------------------------------------------------------
1= 11:11:11:11:11:11
2= 00:00:00:00:00:00
3= 00:00:00:00:00:00
4= 00:00:00:00:00:00
5= 00:00:00:00:00:00
6= 00:00:00:00:00:00
7= 00:00:00:00:00:00
8= 00:00:00:00:00:00
9= 00:00:00:00:00:00
10= 00:00:00:00:00:00
11= 00:00:00:00:00:00
12= 00:00:00:00:00:00
------------------------------------------------------------------------------
Key Settings:
Option Descriptions
Allow or block association from MAC addresses contained in this list. If Allow Association
is selected in this field, hosts with MAC addresses configured in this list will be allowed to
Filter Action
associate with AP. If Deny Association is selected in this field, hosts with MAC addresses
configured in this list will be blocked.
Menu 3.5.1 - WLAN MAC Address Filter
13= 00:00:00:00:00:00
14= 00:00:00:00:00:00
15= 00:00:00:00:00:00
16= 00:00:00:00:00:00
17= 00:00:00:00:00:00
18= 00:00:00:00:00:00
19= 00:00:00:00:00:00
20= 00:00:00:00:00:00
21= 00:00:00:00:00:00
22= 00:00:00:00:00:00
23= 00:00:00:00:00:00
24= 00:00:00:00:00:00
Enter here to CONFIRM or ESC to CANCEL:
All contents copyright (c) 2007 ZyXEL Communications Corporation.
Prestige 2602HWL-D3A Support Notes
25= 00:00:00:00:00:00
26= 00:00:00:00:00:00
27= 00:00:00:00:00:00
28= 00:00:00:00:00:00
29= 00:00:00:00:00:00
30= 00:00:00:00:00:00
31= 00:00:00:00:00:00
32= 00:00:00:00:00:00
99