ZyXEL Communications Prestige 2602HWL-D3A Support Manual page 23

You apply NAT via menus 4 and 11.3 as displayed next. The next figure how you apply NAT for Internet
access in menu 4. Enter 4 from the Main Menu to go to Menu
ISP's Name= MyISP
Encapsulation= PPPoE
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS Type= UBR
My Login= cso@zyxel
My Password= ********
Idle Timeout (sec)= 0
IP Address Assignment= Dynamic
Network Address Translation=
Press ENTER to Confirm or ESC to Cancel:
The following table describes the options for Network Address Translation.
Field
Network Address Translation
Menu 4 - Internet Access Setup
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
IP Address= N/A
Address Mapping Set= 1
Options
Full Feature
None
SUA Only
All contents copyright (c) 2007 ZyXEL Communications Corporation.
Prestige 2602HWL-D3A Support Notes
4-Internet Access
Full Feature
Description
When you select this option the SMT will use Address
Mapping Set 1 (Menu 15.1-see later for further
discussion).
NAT is disabled when you select this option.
When you select this option the SMT will use Address
Mapping Set 255 (Menu 15.1-see later for further
discussion). This option use basically Many-to-One
Setup.
23