Table of Contents
Advertisement
BP7283, High Country, KF160
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One wire stripper
One stepladder
Six wire connectors (supplied)
Three 60-watt (max.) candelabra base bulbs
Three 40-watt (max.) cnadelabra
base round bulbs
Materials
Wiring, outlet box and box connectors
must be of type required by the local code.
The minimum wire would be a 3-conductor
(2-wire with ground) of the following sizes:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Unpacking Instructions
For your convenience, check-off boxes are
provided next to each step. As each step is
completed, place a check mark in the box.
This will insure that all steps have been
completed and will be helpful in finding your
place should you be interrupted.
WARNING
!
Do not install or use fan if any part is
damaged or missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only
those parts supplied with this product
and/or
any
accessories
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
b
a
c
d
7/31/06
10:54 AM
1. Open styrofoam unit containing fan.
Remove top half of styrofoam unit.
Remove parts and check to see that
you have received the following parts:
NOTE: If you are uncertain of part
description, refer to exploded view
illustration.
a. Fan motor housing assembly
b. One upper glass
c. One ceiling cover
d. One decorative cover
e. Five fan blades
f. Five blade flanges
g. One hanger bracket
h. One hanger ball/downrod assembly
Wire Size A.W.G.
i. One 3-1/2" downrod
j. One decorative cap
14
k. One finial nut
12
l. One lower glass
m. One decorative scroll assembly
n. One light fitter adapter
o. One light fitter assembly
p. One remote control transmitter
q. One remote control receiver
r. One loose parts bag, containing:
1. Two 1-1/4" threaded studs
2. Two knurled knobs
3. Two lockwashers
4. Seven wire connectors
5. One hairpin clip
6. One clevis pin
7. Eleven 1/4-20 x 11mm pan head
screws with lockwashers
8. Sixteen 10-24 x 9mm truss head screws
9. Sixteen fiber washers
10. Four 8-32 x 12mm pan head screws
11. Three 8-32 x 15mm pan head screws
12. Three #8 flat washers
13. Three #8 rubber washers
14. One nut 1/8 - 27NPS
designated
15. One lockwasher 1/8 - 27NPS
NOTE: Place the parts from the loose
parts bags in a small container to keep
them from being lost. If any parts are
missing, contact your local retailer or
catalog outlet for replacement before
proceeding.
j
f
k
m
h
i
g
3
Page 3
UP
DN
HIGH
MED
LOW
e
OFF
REV
l
o
n
p
q
r
Advertisement
Table of Contents
