Table of Contents
Advertisement
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
Five wire connectors (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric, Co. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Electric, Co. could result in personal injury
or property damage.
1. Open styrofoam unit containing fan. Remove top half of
styrofoam unit. Remove parts and check to see that you
have received the following:
a. Fan motor and housing assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One switch housing cover
h. One loose parts bag containing:
1. One setscrew
2. One setscrew wrench
3. Eleven 10-32 x 5/8" oval head screws
4. Two 1" threaded studs
5. Two 1-1/4" threaded studs
6. Four knurled knobs
7. Five wire connectors
8. Two 8-32 x 3/8" screws
9. One pull chain pendant and coupling
10. One hairpin clip
11. One clevis pin
12. Four lockwashers
13. Twenty-one 10-32 x 3/8" pan head screws
14. Twenty-one flat washers
One stepladder
One wire stripper
Unpacking Instructions
NOTE: Place the parts from the loose parts bags in
small containers to keep them from being lost. If any
parts
retailer or catalog outlet for replacement before pro-
ceeding.
NOTE: Fan blades are ordered separately and are pack-
aged in separate carton.
3
Get other manuals https://www.bkmanuals.com
Installed Wire Length
Up to 50 ft.
50-100 ft.
WARNING
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
are
missing,
LOOSE
PARTS
BAG
BLADE
FLANGES
CEILING
COVER
Wire Size A.W.G.
14
12
contact
your
local
FAN MOTOR AND
HOUSING ASSEMBLY
HANGER BALL/
DOWNROD
ASSEMBLY
HANGER
BRACKET
MOTOR
COVER
SWITCH
HOUSING
COVER
Advertisement
Table of Contents
