Installation Of 5.25" Front Device Bay; Installation Of 3.5" Front Device Bay; Installation Of 3.5" Internal Device Bay - Gigabyte GZ-FW1CA-AJS User Manual

power connector on the motherboard to
complete the installation
4-6 Installation of 5.25"
Front Device Bay
4-6-1 Open the side panel of the case
and remove the mesh drive rail and
metal EMI plate of the chassis.
4-6-2 Slide in the 5.25" device into the
drive bay from the front of the chassis
and level it with the other mesh drive
rails.
4-6-3 Secure the 5.25" device with the
internal latch. Refer to the figure for
installation procedure.
4-7 Installation of 3.5"
Front Device Bay
Installation of the 3.5" front device is the
same as the 5.25" front devices. Please
refer to step 4-6.
4-8 Installation of 3.5"
Internal Device Bay
The 3D Mercury provides built-in bays to
accommodate up to 5 hard disc drives
(after removal of the tool enclosure). The
built-in HDD requires securing runners
which can be found in the black tool
enclosure.
Required Tools: Securing runners (2 per
hard disc drive)
4-8-1 Fit the securing runners on both
sides of the HDD and slide the HDD into
the internal drive bay.
LOCK
15