Factory Default Settings - Cobalt Digital Inc openGear 9034-SD Owner's Manual

Restore Factory Settings
In this parameter, move the toggle switch up to make the factory default settings active, and make the
stored settings equal to the factory settings.
Information Submenu
Menu Structure
Info
Positive Watts Consumed
A read only indication of power consumed by the card from the frames +12V rail.
Negative Watts Consumed
A read only indication of power consumed by the card from the frames +-7.5V rail.
Software Release Number
A read only indication of the software release number. A higher number is newer release of software.
Software Build Number
A read only indication of the software build number. Software build number is an internal indicator
used by Cobalt engineers to differentiate different software builds.

Factory Default Settings

The factory default settings are as follows
1) The proc module is enabled, but all parameters are set to unity.
2) The audio mapping is for AES Inputs to AES Outputs.
3) Audio gain is set to 0dB and polarity is set to normal on all channels.
4) The Frame Sync is disabled, reference 1 or 2 must be chosen to enable the frame sync.
Page 18 of 28
+POW
-POW
SWR#
SWB#
Parameter Type
Positive Watts Consumed
Negative Watts Consumed
Software Release Number
Software Build Number
9034-SD Owner's Manual • • • • (V 2.0)