Table of Contents
Advertisement
Board Installation
Use the following steps to install the card in the openGear
Warning
This completes the procedure for installing the card in the openGear
9034-SD Owner's Manual • • • • (V 2.0)
1.
Refer to the Owner's Manual of the openGear
is properly installed according to instructions.
Heat and power distribution requirements within a frame may dictate
specific slot placement of cards. Cards with many heat-producing
components should be arranged to avoid areas of excess heat build-up,
particularly in frames using convection cooling.
2.
After selecting the desired frame installation slot, hold the card by the edges and
carefully align the card edges with the slots in the frame. Then, fully insert the card
into the frame until the rear connection plugs are properly seated on the midplane and
rear modules.
TM
8310 frame:
TM
8310 frame to ensure that the frame
TM
8310 frame.
Page 13 of 28
Advertisement
Table of Contents
