Hitachi CP-AW250NM Operating Manual page 21

Setting up
Connecting with your devices (continued)
• If you insert a USB storage device, such as a USB memory, into the USB TYPE
A port and select the port as the input source, you can view images stored in the
77).
device (
• You can connect a dynamic microphone to the MIC port with a 3.5 mm mini-plug.
In that case, the built-in speaker outputs the sound from the microphone, even
while the sound from the projector is output. You can input line level signal to the
MIC port from equipment such as wireless microphone. Select HIGH in the MIC
LEVEL item of the AUDIO menu when you input line level audio signal to the
MIC port. In the normal mode, the volume of the microphone can be adjusted
separately from the volume of the projector using the menu. (
In the standby mode, the volume of the microphone is adjustable with the
VOLUME +/- buttons on the remote control, in synchronization with the volume
of the projector. (
Even when the sound of projector is set to mute mode by the AUDIO SOURCE
45), the volume of the microphone is adjustable.
function (
In both modes (standby or normal), the MUTE button on the remote control
works on the sounds of the microphone and the projector. (
USB storage
device
USB
TYPE A
DC5V
0.5A
CAUTION
projector, be sure to use the REMOVE USB function on the thumbnail screen to
secure your data (
• If a loud feedback noise is produced from the speaker, move the
NOTE
microphone away from the speaker.
• This projector doesn't support plug-in power for the microphone.
(continued on next page)
12
20)
Microphone system
Monitor
RGB IN
HDMI
USB TYPE B
MONITOR OUT
CONTROL
►Before removing the USB storage device from the port of the
80).
(with an amplier)
COMPUTER IN2 COMPUTER IN1
MIC AUDIO OUT
AUDIO IN1 AUDIO IN3
AUDIO IN2
46)
20)
Speakers
R L
S-VIDEO
VIDEO