Cisco SCE 1000 Installation And Configuration Manual page 79

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure
trap status. (See step 14.)
Step 10 Type the trap manager IP address and press Enter.
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Type the trap manager community string and press Enter.
Step 11
Note that there is no default for this parameter.
Enter SNMP trap manager community string:
Step 12 Type the number of the trap manager SNMP version (1 or 2c) and press Enter
Note that there is no default for this parameter.
Enter trap manager SNMP version:
Step 13 The maximum number of trap managers is 20.
Would you like to add another SNMP trap manager? [no]:y
Enter up to 20 trap managers as described in step 10 through step 12.
Would you like to add another SNMP trap manager? [no]:
Configure the Authentication Failure trap status.
Step 14
Enable the 'Authentication Failure' trap [no]:
Configure the SCE enterprise trap status.
Step 15
Enable the SCE enterprise traps []:
Type the name of the system administrator and press Enter.
Step 16
Note that there is no default for this parameter.
Enter system administrator contact name []:
E
XAMPLE
Following is a sample SNMP configuration, configuring one trap manager, one GET community,
and one SET community, and enabling the authentication failure trap, as well as all enterprise
traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0'
to allow all: 0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0'
to allow all: 2
Would you like to add another SNMP SET community? [no]:
OL-7821-04
To add more entries, type y and press Enter
•
• When all entries have been added, press Enter
To disable the Authentication Failure trap, press Enter.
•
To enable the Authentication Failure trap, type y and press Enter.
•
To disable the SCE enterprise traps, type n press Enter.
•
To enable the SCE enterprise traps, type y and press Enter.
•
:
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Initial System Configuration
5-17