Marantz AV7005 User Manual page 83

Setting items
Speaker Config. F.Wide : Set the presence and size of the front wide speakers.
(Continued) • Large : Use a large speaker that can adequately play back low
frequencies.
• Small : Use a small speaker that has inadequate playback capacity for
low frequencies.
• None : Select when the front wide speakers are not connected.
NOTE
When "Amp Assign" setting (vpage 78) is other than "Normal", you
cannot make the "F.Wide" setting.
Bass Setting Subwoofer Mode : Select low range signals to be reproduced by
Set subwoofer and LFE subwoofer.
signal range playback. • LFE : The low range signal of the channel set to "Small" speaker size is
added to the LFE signal output from the subwoofer.
• LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer.
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 78) is set to "Yes".
• Play music or a movie source and select the mode offering the strongest
bass.
• Select "LFE+Main" if you want the bass signals to always be produced
from the subwoofer.
NOTE
If "Front" and "Center" for "Speaker Config." are set to "Large", and
"Subwoofer Mode" is set to "LFE", no sound may be output from the
subwoofers, depending on the input signal or selected surround mode.
LPF for LFE : Set LFE signal playback range.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
Distance Unit : Set the unit of distance.
Set distance from listening • Feet / Meters
position to speakers.
Step : Set the minimum variable width of the distance.
Measure beforehand the
• 1ft / 0.1ft
distance from the listening
• 0.1m / 0.01m
position to each speaker.
Front L / Front R / Center / Subwoofer / Surround L / Surround R /
z
S.Back L / S.Back R
: Select the speaker.
z When the "Speaker Config." – "S.Back" setting (vpage 78) is set to
"1spkr", "S.Back" is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
Remote control operation
buttons
SVENSKA NEDERLANDS
Setting details
z
/ F.Height L / F.Height R / F.Wide L / F.Wide R
Move the cursor
(Up/Down/Left/Right)
ESPAÑOL ITALIANO
Setting items
Distance
(Continued)
• The speakers that can be selected differ depending on the "Amp Assign"
(vpage 78) and "Speaker Config." (vpage 78) settings.
• Default settings :
Front L / Front R / Center / Subwoofer / F.Height L / F.Height R / F.Wide L /
F.Wide R : 12.0 ft (3.6 m)
Surround L / Surround R / S.Back L / S.Back R : 10.0 ft (3.0 m)
• Set the difference in the distance between the speakers to less than 20
ft (6.0 m).
NOTE
Speakers set to "None" in "Speaker Config." (vpage 78) are not displayed.
Default : The "Distance" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
prompt is displayed. Select either "Yes" or "No", and press
Channel Level Test Tone Start : Output test tone.
Set the volume of the test • Front L / F.Height L / Center / F.Height R / Front R / F.Wide R /
tone to be the same when it Surround R / S.Back R
is output from each speaker. Subwoofer : Select the speaker.
z When the "Speaker Config." – "S.Back" setting (vpage 78) is set to
"1spkr", "S.Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
o
• When is pressed while the subwoofer volume is set to "–12 dB", the
"Subwoofer" setting switches to "OFF".
• When "Channel Level" is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 56.
• When you press
this setting item immediately.
NOTE
• Speakers set to "None" in the "Speaker Config." (vpage 78) settings
are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Channel Level" is not displayed.
Default : The "Channel Level" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
prompt is displayed. Select either "Yes" or "No", and press
Confirm the setting
FRANÇAIS DEUTSCH
Manual Setup
Setting details
ENTER
, the "Default Setting?"
z z
/ S.Back L / Surround L / F.Wide L /
TEST TONE
on the remote control unit, you can enter
ENTER
, the "Default Setting?"
Return to previous menu
ENGLISH
ENTER
.
ENTER
.
79