Marantz AV7005 User Manual page 35

n Checking the SIRIUS signal strength and radio
ID
1
STATUS
Press until
"SIGNAL" appears on the
display.
The display will switch as
shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
2
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
3
Press STATUS until the channel (example: "SR001")
is displayed.
4
Press TUNING + or TUNING –
and select channel 0 (SR000).
Channel No. and Sirius ID are alternately
shown on the display.
SR000 SiriusID
Sirius ID
************
• Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can be
checked "Antenna Aiming" (vpage 68).
SVENSKA NEDERLANDS ESPAÑOL
n Presetting radio channels (Preset memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel
you want to preset.
2
MEMORY
Press .
3
Press SHIFT to select the block
(A to G) in which to preset the
channel (1 to 8 per block), then
PRESET + PRESET –
press , or
8 to select the preset number.
4
Press MEMORY again to complete
the setting.
• To preset other stations, repeat steps 1 to
4.
NOTE
Preset channels are erased by overwriting them.
n Listening to preset channels
Press PRESET + , PRESET – to select
the desired preset channel, then press
ENTER .
• Preset channels can also be selected by
SHIFT/TOP MENU
pressing (Block) and
8
(Channel).
ITALIANO FRANÇAIS
You can also operate via the main unit. In this
case, perform the following operations.
Press o p to select the preset radio channel.
n Searching categories
1
Press
o p
1 –
SR001 Hits 1
CAT : Pops
2
Use
o p
the desired channel.
n Accessing SIRIUS satellite radio channels
directly
1
SEARCH/INFO
Press
2
0 – 9
Press
Example: Accessing channel "SR123":
1 2
Press ,
• If no button is pressed within several
seconds,
1 –
switches to the one whose number has
been input.
3
ENTER
Press
Reception switches to the selected
channel.
• "UPDATING" is displayed while the encording code is being
updated.
• "SIRIUS UPDATING" is displayed when updating SIRIUS tuner
firmware.
• Refer to "Troubleshooting" – "SIRIUS Satellite Radio" (vpage 113)
regarding other messages.
DEUTSCH ENGLISH
Tuning in radio stations
.
Channel category
to select the category, to use to select
ui
.
to input the channel.
3
and .
the channel automatically
to set that channel.
31