Main Menu - Duerkopp Adler 540-100-1 Operating Instructions Manual

4.3 Main menu

Symbol Parameter
Buttonhole number
N1
Thread tension
N2
Cut length
N3
Speed
N4
Soft start
N5
Daily quantity counter
N6
Hook thread counter
N7
Repair mode
N8
20
Meaning
Selection of the buttonhole to be sewn
- Program number 1 to 50 contains
buttonhole programs. Program number 51
and 52 contain free contour sewing
programs.
- The preprogrammed form of the chosen
buttonhole is shown in the left half of the
display.
- Additionally an info window is shown with
some buttonhole specific values:
- Cut length
- Intermediate fabric
- Buttonhole seam stitch length
- Buttonhole width
Selection of the submenu for changing the
thread tension values. Only visible when
the electric thread tension control is
activated
- Selection of buttonhole cut length
from 6 – 65 mm
- The setting is dependent of the buttonhole
number.
- Selection of sewing speed for the buttonhole
to be sewn from von 200 - 4000 RPM.
The setting is dependent of the buttonhole
number.
- If the set sewing speed is less than the soft
start speed a cautionary warning is
displayed and the soft start is switched off.
- The high speed that is here selectable can
be set in the technician level.
Soft start switch on and off
- Number of soft start stitches and their
sewing speed can be preset in the
technician level.
The daily quantity counter counts the number
of sewn buttonholes.
- By pressing the "OK"- key twice, the daily
quantity counter will be reset to zero.
Display of the current hook thread counter
state (when active) and selection of the
submenu for the changing of the initial value
and for the switching on and off of the hook
thread counter.
Repair mode.