3.2 Winding the hook thread
3.3 Changing the bobbin
8
1
2
3
Threading the hook thread is independent of sewing operation.
–
Put the thread on the thread stand.
–
Thread the hook as shown in the picture.
–
Put the empty bobbin onto the bobbin winder 1.
–
Wind the hook thread clockwise about 5 times around the bobbin
core.
–
Swing winder lever 2 towards spool and click in.
The thread will be wound on.
–
Winder lever 2 ends the spooling event when the bobbin is full.
–
After spooling snap out the bobbin thread from thread clamp 3.
Caution: Danger of injury !
The bobbin should only be changed when the sewing automat is
switched off.
Remove empty bobbin.
–
Open bobbin case lid.
–
Flip up the clip 5 and remove the top of the bobbin housing with
bobbin.
–
Remove the bobbin from the top of the bobbin housing.