Duerkopp Adler 540-100-1 Operating Instructions Manual page 37

P6.1/ P7.1 E Cross tack (vertical)
Tack stitch distance
P 6.2/ P 7.2
Tack length
P 6.3/ P 7.3
Tack width
Right offset
P 6.4/ P 7.4
Tack width
Left offset
P 6.5/ P 7.5
Moving tack at
the top
P 6.6/ P 7.6
Moving tack at the
bottom
P 6.6/ P 7.6
Tack tension
P 6.7/ P 7.7
P6.1/ P7.1 G Eye tack
Tack width
P 6.5/ P 7.5
Tack stitch number
P 6.3/ P 7.3
Tack tension
P 6.7/ P 7.7
P6.1/ P7.1 H Simple tack (bartack),
Stitch distance within
the buttonhole seam
P4.2
Buttonhole width
P 4.3
Buttonhole seam
tension
P 4.4
Stitch length of
tacking stitches
P 4.6
Thread tension of
tacking stitches P 4.7
0.2 ... 1.0 mm
0.6 ... 6.0 mm
-1.0 ... 1.0 mm
-1.0 ... 1.0 mm
-1.0 ... 0 mm
0 ... 1.0 mm
on / off
2.0 ... 6.0 mm
2 ... 50
on / off
0.2 ... 1.0 mm
1.0 ... 6.0 mm
on / off
0.2 ... 3.0 mm
on / off
Distance in the y-axis of a double stitch
Length of the tack in the y-axis. The input of
parameter P7.3 is only possible when the top
and bottom tack types at are not similar!
The width of the tack is defined through the
buttonhole width. With the use of right offset
the width of the tack to the right can be
increased.
The width of the tack is defined through the
buttonhole width. With the use of left offset the
width of the tack to the left can be increased.
The position of the tack can be pushed down.
The position of the tack can be pushed up.
on: raised form tack
off: flat form tack
External diameter of the eye
Number of outer stitches, that will form the
semicircular tack.
on: raised form tack
off: flat form tack
The parameter of the special tack types H
simple tack are changed with the buttonhole
seam parameters.
Distance in the y-axis of a double stitch
Total width of the buttonhole
on: raised form
off: flat form
Stitch distance of tacking stitches
Tacking stitch seam resistance
1
35