Duerkopp Adler 540-100-1 Operating Instructions Manual page 36

P6.1/ P7.1 A cross tack(horizontal) ,
Tack stitch distance
P 6.2/ P 7.2
Tack length
P 6.3/ P 7.3
Tack width
Right offset
P 6.4/ P 7.4
Tack width
Left offset
P 6.5/ P 7.5
Tack tension
P 6.7/ P 7.7
P6.1/ P7.1 B Round tack (to the middle point)
Tack stitch number
P 6.6/ P 7.6
Tacking tension
P 6.7/ P 7.7
P6.1/ P7.1 C Taper tack
Tack stitch distance
P 6.2/ P 7.2
Tack length
P 6.3/ P 7.3
Tack tension
P 6.7/ P 7.7
P6.1/ P7.1 D Round tack (horizontal)
Tack stitch distance
P 6.6/ P 7.6
Tack tension
P 6.7/ P 7.7
34
F Cross tack (divided)
0.2 ... 1.0 mm
0.6 ... 6.0 mm
-1.0 ... 1.0 mm
-1.0 ... 1.0 mm
on / off
2 ... 50
on / off
0.2 ... 1.0 mm
0.6 ... 9.0 mm
on / off
0.3 ... 1.0 mm
on / off
Distance in the y-axis of a double stitch.
Length of the tack in the y-axis. The input of
parameter P7.3 is only possible when the top
and bottom tack types are not similar!
The width of the tack is defined through the
buttonhole width. With the use of the right
offset the width of the tack to the right can be
increased.
The width of the tack is defined through the
buttonhole width. With the use of the left offset
the width of the tack to the left can be
increased.
on: raised form tack
off: flat form tack
Number of stitches, that form the semicircular
tack.
on: raised form tack
off: flat form tack
Distance in the y-axis of a double stitch
Length of the tack in the y-axis
on: raised form tack
off: flat form tack
Distance in the y-axis of a double stitch
on: raised form tack
off: flat form tack