Adjusting The Cut Length; Selecting A Start Variant - Duerkopp Adler 540-100-1 Operating Instructions Manual

5.4 Adjusting the cut length

5.5 Selecting a starting variant
30
Correcting the buttonhole length (Cut length). The adjustment is
possible in both, the main menu and programming mode.
Select the line "cut length" in the main menu with the arrow keys ñ
–
and ò
–
Press the OK-key.
The curser blinks under a digit value.
Change between the digits with the arrow keys ï and ð.
–
–
Increase or decrease the value of the selected digit with the arrow
keys ñ and ò.
–
Press the OK-key to confirm the value.
Select a starting variant
The starting variant of the starting stitch serves to ensure the correct
sewing start for different materials and threads. The starting variant is
individually set for each individual buttonhole.
Starting variant A (Standard)
–
The starting stitches are flat form stitches.
Starting variant B (Thin material, lining)
–
The starting stitches are flat form stitches. With the use of a cross
stitch the upper thread holds better to the material.
Starting variant C (very thin material)
–
The starting stitches are flat form stitches.
With the use of forward and backward bartack stitches the upper
thread holds better to the material.
Starting variant D (very thin material)
–
Alternative to starting variant C.
Select starting variant:
–
Press P-key.
Select the line "Starting variant" with the arrow keys ñ and ò.
–
–
Press the OK-key.
–
Select the relevant Starting variant A, B, C or D with the arrow
keys ñ and ò
–
Press the OK-key
–
Press the ESC-key.