5.4
Winding on the hoo thread
2
1
12
CAUTION:
Only special bobbins suitable for this type of machine may be used!
The matt side of the bobbin
–
Place the needle-thread cone onto the thread stand.
–
Pass the needle thread through the thread guide on the take-up
arm and through pre-tensions 1 and 2 as shown in the illustration.
–
Carefully wind a few turns of thread anti-clockwise onto the reserve
groove 6 of the bobbin by hand and place the bobbin on the thread
stand with the ring 3 and the matt surface towards the operator.
–
Swivel the bobbin-winder lever 5 against the empty bobbin.
–
Enter the bobbin number via the Touch Screen Monitor.
When the bobbin is full, winding is automatically stopped by the
bobbin-winder lever 5.
Caution!
Before you press the ENTER key, please ensure that the number
entered does in fact correspond to the number engraved on the
bobbin.
–
Adjust pre-tensions 1 and 2.?
The thread should be wound on at as low a tension as possible.
3
4
5
6