Hitachi D36WF840N Instruction Manual page 9

Please Note : If you only want to connect a VCR to your television, follow the diagram
below. If you also want to connect a DVD Player or Digibox to your Television, please
Please Note : Your TV is supplied with 2 RF leads. One of these leads has a 'block' at each end. This is the
TV Setup
AERIAL
VCR
1
Connect your aerial flylead to the digital 'link' lead. Keep the flylead as short as possible and replace
Connect the digital 'link lead' to TV 'in' socket marked
2
above carefully when connecting the digital 'link lead', as there are 2 sockets marked
3
Connect TV 'out' to VCR 'in' socket. This socket may also be marked
4
* Scart leads should be
fitted between your TV and
other equipment to enhance
your picture and sound quality.
Scart leads are essential if you
have a stereo TV and VCR and wish to
obtain stereo sound from your
equipment. These leads can be
purchased from your Hitachi
dealer or any good High Street
electrical retailer.
see the 'Advanced TV Setup' overleaf.
digital 'link lead'. Connect as shown in the diagram below.
ADAPTOR
1
3
SCART LEAD * (optional)
with an adaptor if feasible.
your TV. Use the socket on the left.
Connect VCR 'out' to TV 'in' socket marked
VHS video equipment
should be connected to the
AV1 scart socket located at the
rear of your TV. A dedicated
programme number may be
assigned to AV1, allowing you easier
access to external equipment
viewing. How to assign an AV signal
to dedicated programme numbers is
explained in signal source entry
2
RF LEADS (2 SUPPLIED)
. Please Note: Follow the diagram
section.
4
at the rear of
.
.
IMPORTANT
NOTE :
When you connect
your VCR to your
television, the
Audio Visual option
has to be set correctly to
ensure best picture
quality - see audio
visual setup section.
9