Using Terminal Mode To Enter At Commands; Using Video - Hayes V.92 User Manual

If your software does not handle AT commands automatically, it
should provide a place to enter AT commands in its setup menus.
However, in some cases you may need to enter AT commands
directly to the modem. You must do so from a data program's
terminal mode.
Using Terminal Mode to Enter AT
Commands
1
Start your data communications program.
2
Change to terminal mode (also called command, local, direct, or
dumb mode). Check your software documentation for additional
instructions.
3
Type AT plus the command you need and press Enter. You will
see an OK response.
4
When you finish, you can return to the data communications
program's standard user interface. See the software program's
documentation if you need help.
To return to the factory default settings for the modem, in terminal
mode, type AT &F and press Enter.
Refer to the Troubleshooting
AT commands.

Using Video

Your faxmodem supports video applications through the V.80
standard protocol so that it can be used for high-quality modem-to-
modem videoconferencing. The modem is compatible with H.324
point-to-point and H.323 Internet video conferencing standards. To
send videos, you need a camera and video software.
section on page 32 for more tips about
31