DURKOPP ADLER 767 Service Instructions Manual page 72

Hide thumbs Also See for 767:

Table of Contents

6. Adjusting the roller 11 as to the cam disc 8.

–

Turn the handwheel until the roller 11 abuts on the highest point of

the cam disc 8.

Note:

At the highest point the roller 11 has the furthest distance from the

rotation axis of the cam disc.

Standard:

Between the highest point of the cam disc 8 and the roller 11 there

might be a distance of max. 0.1 mm. The roller 11 must still be

rotatable.

max. 0,1 mm

–

Press the piston rod of magnet 10 in the direction of the arrow and

screw lever 1 tight.

Check whether everything is running smoothly.

Check:

Move the thread pulling knife 12 in its rear position (cutting position) by

hand. No clearance must be felt.

Correction:

–

Loosen the screw at block 7.

Turn the piston rod

in clockwise direction = less clearance,

counter-clockwise

between roller 11 and cam disc 8.

= more clearance,

Table of Contents