DURKOPP ADLER 767 Service Instructions Manual page 26

Hide thumbs Also See for 767:

Table of Contents

Correction

–

Unhook the spring at the stitch regulator lever.

–

Screw off screw 3 and pull setting wheel 2 off.

–

Turn the spindle 7 to the right with a 10 mm open-end wrench until

block 10 has the least possible clearance (see item 3.1).

ATTENTION !

Do not turn the spindle 7 to the right too far. The stitch regulator

parts might jam, and the maximum stitch length of 9 mm or

6 mm is no longer reached.

–

Set scale 1 at "0".

–

Put the setting wheel 2 on again and tighten with screw 3.

–

Put spring in again.

–

Loosen screw 5 at the second setting wheel.

–

Pull off setting wheel 6.

–

Turn the spindle of the second setting wheel to the right with a

10 mm open-end wrench until a resistance can be felt.

–

Set the scale 4 at "0".

–

Put the setting wheel 6 on again and tighten with screw 5.

Table of Contents