DURKOPP ADLER 767 Service Instructions Manual page 65

Hide thumbs Also See for 767:

Table of Contents

5. Set the piston rod of the magnet 10.

–

Loosen the block 7 on the piston rod of the magnet 10.

–

Twist the piston rod completely on the block 7 and tighten it.

6. Set the thread-pulling knife 12 with the gauge Y

(Part-No. 0767 290020).

–

Position the roll 11 against the trimmer disc 8.

–

Position the trimmer disc 8 to its lowest position by turning the

handwheel.

(Lowest position: where the roll 11 comes closest to the axis of

rotation of the disc 8). The thread-pulling knife abut on the gauge Y,

see picture.

–

Tighten the clamping screw 5.

–

Screw off the gauge Y.

7. Set the roll 11 to the thread trimmer disc 8.

–

Turn the machine using the handwheel, so that the roll 11 clings to

the highest point of the thread trimmer disc 8.

(Highest position: where the roll 11 is furthest from the axis of

rotation of the thread trimmer disc 8).

–

There should be a clearance of 0.1 mm between the roll 11 and the

peak of the trimmer disc 8.

–

Press the rod of the magnet 10 downward in the direction of the

arrow and tighten the clamping screw 1 in this position.

–

Check whether all moving parts are running smoothly.

Table of Contents