32
1
2
3
X14
4
Correction
If the mentioned values are not correct, the position of potentiometer 1
has to be readjusted.
–
Loosen core pin 4.
–
Adjust shaft of potentiometer 1 in such a way that the
corresponding resistance is achieved.
–
Push potentiometer completely in the drill-hole of setting shaft 2.
–
Tighten core pin 4 again.
Checking and adjusting of the potentiometer is also possible with the
Efka control DA82GA with control panel V810 or V820
(see chapter Controls and Control Panel Efka).