5.
Changing the cutting blocks
18
1
2
Two cutting blocks are available. The cut length can be changed by
switching cutting blocks.
Caution: danger of injury
Cutting blocks may only be switched with the machine switched off or
in the "Safe Stop" position.
Removing the cutting-block
–
Remove clamp plates (see section 3.2).
–
Remove the cutting-block 1 by raising it at the position indicated by
the arrow.
Fitting the cutting-block
–
Insert the cutting-block in the cutting-block holder 2.
–
Check that the cutting-block is firmly seated in its holder 2 (make
sure that the pins are properly fitted into the notches).
–
Fit clamp plates (see section 3.2).