Table of Contents
Advertisement
VERSA•TOUCH2™ CONTROL INSTALLATION
VERSA•TOUCH2™ HARDWARE (not to scale)
W-73
W-73
Control Holder
Control
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with
an isolating wall control/switch. CAUTION! Do not use with wall dimmer.
Step 14. Follow instructions for the type of transmitter control bracket you will be using.
Inner
mounting
holes
Control
Bracket
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided
screwdriver.
Wall Installation
Step A. Locate a 2x4 wall
stud in a convenient
location.
Step B. Orient the control
bracket as shown over the
2x4 stud.
Step C. Insert the 1" wood
screws in either the inner
or outer mounting holes
and tighten using the
provided screwdriver.
10
Drywall Anchor
12v Battery
CONTROL BRACKET INSTALLATION
Standard
Toggle
Switch
Switch
Cover
Plate
Wood
Screw
6-32 (2)
1" (2)
Outer
mounting
holes
Control
Bracket
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step D. Insert and tighten the screws using the provided
screwdriver.
NOTE: The wall anchors and 6-32 x 1" screws may be
used in situations where mounting to a stud is not possible.
Use the inner mounting holes. After securing the anchor,
discard the anchor's pointed screws and use the 6-32 decor
ovalhead screws supplied.
Anchor
Panhead
Screw
Wood
Screw 1"
Screw
Screw
6-32 X
/
"
6-32 X 1"
3
8
(2)
(2)
Rocker
Light
Switch
Switch
Cover
Plate
Drywall Anchor
Decor Ovalhead Screw
6-32 X 1"
Advertisement
Table of Contents
