Pci Retainer - HP Xw4550 - Workstation - 2 GB RAM Technical Reference Manual

Table 4-5 PCI slots
Slot
1
2
3
4
* In addition to these slot power specifications, the overall power consumption of the system
(including I/O cards, processor, and memory) must not exceed the maximum ratings of the
system power supply.

PCI retainer

For added protection, some cards have PCI retainers installed to prevent movement during shipping.
To remove the PCI retainer:
1. Disconnect power from the system
access panel
2. Remove the two screws (1) retaining the retainer and lift it (2) out of the chassis.
Figure 4-33
To install the PCI retainer:
1. Disconnect power from the system
access panel
2. Engage the rear bracket (1) with the holes in the rear of the chassis before rotating it down (2) into
position. .
ENWW
Type
PCI Express x16
PCI Express x4(1)
PCI 32/33
PCI 32/33
(Side access panel on page
Removing the PCI retainer
(Side access panel on page
Slot power (Maximum)
75 W*
25 W*
25 W*
25 W*
(Predisassembly procedures on page
59).
(Predisassembly procedures on page
59).
Steps for removing and replacing components
55) and remove the side
55) and remove the side
81