HP Xw4550 - Workstation - 2 GB RAM Technical Reference Manual page 39

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
* Available on selected models.
**These options should be used by advanced users only.
ENWW
Option
●
F9 Prompt (Enable/Disable). Enabling this feature displays the text F9=Boot Menu during
POST. Disabling this feature prevents the text from being displayed. However, pressing the
F9 key still accesses the boot menu.
● F10 Prompt (Enable/Disable). Enabling this feature displays the text F10=Setup during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen.
●
F11 Prompt (Enable/Disable). Makes the Factory Recovery option visible during POST.
Disabling this feature prevents the text from being displayed, but pressing F10 still accesses
the Setup screen. Factory Recovery Boot Support must be enabled to use this option.
●
F12 Prompt (Enable/Disable). Enabling this feature displays F12=Network Service Boot
during POST. Disabling this feature prevents the text from being displayed but pressing F12
still forces the system to attempt booting from the network.
● Factory Recovery Boot Support (Enable/Disable). Recovery partition (HDD) option available.
Vista leaves the factory with this support in place.
● Option ROM prompt* (Enable/Disable). Enabling this feature causes the system to display a
message before loading options ROMs.
● Remote Wakeup Boot Source
●
After Power Loss (On/Off); the previous state is the default.
●
POST Delay (in seconds) (Enable/Disable). Enabling this feature adds a user-specified delay
to the POST process. This delay is sometimes needed for hard disks on some PCI cards that
spin up slowly—so slowly that they are not ready to boot by the time POST is finished. The
POST delay also gives you more time to select F10 to enter the Computer Setup (F10) Utility.
● Limit (CPUID Maximum Value to 3) (Enable/Disable)
Execute Tests workstation memory. The workstation reboots and any changes that have been made are
Memory Test lost. The workstation might boot with memory in a sub-optimal configuration.
BIOS Power-On Enables you to disable or specify a weekday and time for BIOS power-on.
Onboard Enables you to set resources for or disable onboard system devices such as serial ports and
Devices diskette controllers. Operating system parameters generally override Onboard Devices settings.
Bus Options The options are:
●
PCI SERR# Generation (Enable/Disable)
●
PCI VGA Palette Snooping (Enable/Disable)
● ECC Support (Enable/Disable)
●
Device Options Num Lock State at Power-On (off/on)
● S5 Wake-on-LAN (Enable/Disable)
●
Processor Cache (Enable/Disable)
●
Internal Speaker (Enable/Disable)
● Monitor Tracking (Enable/Disable)
●
NIC PxE Option ROM Download (Enable/Disable)
●
SATA RAID Option ROM Download (Enable/Disable)
● HPET (Enable/Disable)
Description
Computer Setup (F10) Utility 31