HP Xw4550 - Workstation - 2 GB RAM Technical Reference Manual page 79

4. If the drive is to be replaced, remove the four installation guide screws (2), as shown in the following
figure, and set them aside.
Figure 4-21
To install an optical drive:
1. Disconnect power from the system
access panel
on page
2. If reinstalling an original optical drive, go to the next step. If installing a new drive or replacing the
original drive with replacement drive, insert four installation guide screws into the drive housing (1),
as shown in the following figure.
Figure 4-22
3. Align the guide screws with the grooves in the desired drive bay and gently slide the drive into the
workstation until it snaps into place (2), as shown in the preceding figure.
CAUTION:
disengaged. Failure to do so can cause damage to the drive when moving the workstation.
ENWW
Removing the optical drive screws
(Side access panel on page
62).
Installing the optical drive
Ensure that the optical drive is secure by pulling to see if the drive can become easily
(Predisassembly procedures on page
59) and remove the front bezel
Steps for removing and replacing components
55), remove the side
(Front Bezel
71