HP Xw4550 - Workstation - 2 GB RAM Installation Manual
Sas/sata hard drive
Hide thumbs
Also See for Xw4550 - Workstation - 2 GB RAM:
- Service and technical reference manual (158 pages) ,
- Technical reference manual (154 pages) ,
- Quickspecs (65 pages)
Advertisement
Quick Links
SAS/SATA hard drive installation
HP xw Workstation series
This document describes how to install a Serial Attached SCSI (SAS) and Serial ATA (SATA) hard disk
drive (HDD) on your workstation.
Kit contents
Ensure that the following components are included in your drive kit:
●
a SATA or SAS HDD
●
Multiple SATA interface cables (each of a different length and with different connector orientation
combinations)
●
SAS-to-SATA interface adapter
●
Four M3 guide screws
●
Warranty
ENWW
© 2007 Hewlett-Packard Development Company, L.P. The HP Invent logo is a
registered trademark of Hewlett-Packard Development Company, L.P. Microsoft and
Windows are U.S. registered trademarks of Microsoft Corporation. Printed in the U.S.
Kit contents
1
Advertisement
Related Manuals for HP Xw4550 - Workstation - 2 GB RAM
Summary of Contents for HP Xw4550 - Workstation - 2 GB RAM
-
Page 1: Kit Contents
Four M3 guide screws ● Warranty © 2007 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. Microsoft and Windows are U.S. registered trademarks of Microsoft Corporation. Printed in the U.S. ENWW... -
Page 2: Your Responsibilities
Your responsibilities You are responsible for determining whether the product is appropriate for your use and will function with other equipment without malfunction or damage. You are also responsible for backing up data before installing any product and for regularly backing up data after installing the product. HP is not liable for any damage to equipment or data loss resulting from the use of any product. -
Page 3: Preparing For Installation
CAUTION: Static electricity can damage the electronic components of the workstation. Before beginning these procedures, be sure you are discharged of static electricity by briefly touching a grounded metal object. CAUTION: Observe the following cautions when removing or replacing a processor: —... -
Page 4: Installing The Hard Drive
● Keep the original packing materials for future transportation of the drive. ● If any object or liquid falls into the cabinet, immediately unplug the workstation and have it checked by an authorized service provider. Installing the hard drive NOTE: For specific information relating to your workstation, refer to www.hp.com/go/bizsupport. -
Page 5: Configuring The Computer
Connect the power cable (1) and data cable (2) to the hard drive. Connect the opposite end of the data cable to the system board or controller card. CAUTION: To avoid any hard drive performance problems, connect the primary hard drive to the connector on the system board labeled SATA 0 or SAS 0, depending on hard drive type. - Page 6 System configuration is the process of specifying the devices and programs that make up a computer system. When you add or remove accessories, the computer must be configured to recognize these changes. Turn on the computer and read the messages displayed during startup. ●...