List Of Error Codes Without Messages - Canon ImageRUNNER 2830 Facsimile Manual

NetWare is in use. Wait for a moment, then perform operation again.
Cause
Remedy
Check the TCP/IP.
Cause
Remedy
Cannot find the selected server. Check the settings.
Cause
Remedy 1 Check the DNS Server Settings in TCP/IP Settings in Network Settings in
Remedy 2 Check whether the DNS server's DNS settings are correct.
Cannot connect to the selected server. Check the settings.
8
Cause
Remedy

List of Error Codes without Messages

If an error occurs while a document is being sent or received, an error code is
displayed on the job log on the System Monitor screen, and is included in various
reports. Check what the error code is, and then take the required steps to solve the
problem. (See Chapter 4, "Checking/Changing the Fax Status," and "Report and
List Samples," on p. 9-2.)
8-8
Error Messages
You cannot browse the network because NetWare is printing through a PServer
or NDS PServer.
Wait until printing is complete, and try browsing again.
The machine's TCP/IP connection is not operating.
Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)
The IP address that the machine should connect to cannot be determined.
System Settings (from the Additional Functions screen). (See Chapter 3, "Using
a TCP/IP Network," in the Network Guide.)
The machine cannot connect to the specified IP address/port.
Check the Gateway Address setting in IP Address Settings in TCP/IP Settings
in Network Settings in System Settings (from the Additional Functions screen).
(See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)