Install/Remove Hdd Units; Install The Hdd Units - Panasonic WJ-HD616/1000 Installation Manual

Install/remove HDD units

Install the HDD units

Install the HDD units by referring the disk slot number.
Detach the front cover in advance. (+ Page 21)
Step 1
Remove the HDD unit brace.
HDD unit brace
Step 2
Install the HDD units by referring the disk slot number.
(1) Lift the lever on the HDD unit while holding down the
removal knob, and then insert the HDD unit all the way
into the HDD slot.
Removal
knob of the
HDD unit
Lever
(2) Pinch the rim on the HDD slot with the hook on the HDD
unit securely.
52
Removal knob
(3) Press the lever down and push it until the removal knob
of the HDD unit
clicks.
Lever
(2)
Hook
(3)
Important:
• Keep the removed HDD unit brace securely. When trans-
porting the recorder, it is necessary to attach it.
• Hard disk drives are precise devices. Handle with care
while keeping the following in mind.
• Do not subject the hard disk drive to any vibration or
impact.
Before touching the hard disk drive, eliminate static elec-
tricity by touching a steel locker, etc. When holding the
hard disk drive, hold the both sides of the hard disk
drive.
• Do not touch the circuit board or the connectors to pre-
vent the hard disk drive from damaging by static electric-
ity.
• Contact your dealer for hard disk drives that works on
the recorder. Please be forewarned that operation with
any hard disk drive other than the specified models is
not guaranteed under any circumstances.
• When using multiple hard disk drives, use the same
model.
If different models are used together, even when the
capacities of them are the same, the available capacity
may be a few percent smaller.
• Install the hard disk drives one by one in order starting
from HDD1.(The leftmost slot of the HDD slots is HDD1
and the rightmost one is HDD4.)
• Once the operation has started in the RAID 5 or RAID 6
mode, do not change the positions of the HDD units. If
they are changed, it may become impossible to read
recorded data.
Rim