Specifications - Panasonic WJ-HD616/1000 Installation Manual

Specifications

• General
Power source:
Power consumption:
Ambient operating temperature:
Ambient operating humidity:
Maximum operating altitude:
Dimensions (excluding rubber
feet and projections)
Weight:
Finish:
• HDD (Locally procured - Contact your dealer about purchasing hard disk drives.)
Hard disk drive:
• Input/output
Video
Video input connector:
Cascade input connector:
Video output connector:
Monitor output connector:
Monitor (HDMI) connector:
Video output connector (front):
Audio
Audio input connector:
Cascade input connector:
Audio output connector:
Audio output connector (front):
Others
External storage connector:
Mouse connection port:
Alarm/control terminal:
Alarm terminal:
RS485 port:
DATA port:
Network port:
Maintenance port:
SDHC/SD memory card slot:
*1 When power is not supplied, the video output signal was not sent from the recorder even if a video input signal is supplied.
*2 Non-voltage make contact input, 50 kΩ +5 V DC pull-up
120 V AC, 60 Hz
130 W
+5 °C to +45 °C {+41 °F to +113 °F}
5 % to 90 % (non condensing)
When installing WJ-HDB611: 10 % to 80 % (non condensing)
2 000 m {6 562 feet} or less
430 mm (W) x 132 mm (H) x 400 mm (D) {16-15/16"" (W) x 5-3/16" (H) x 15-3/4" (D)}
When no hard disk drive is installed: 14 kg {30.91 lbs.}
When 4 hard disk drives are installed: 17 kg {37.53 lbs.}
Front cover: Solid metallic coating
Top cover: Solid metallic coating
Rear panel: Galvanized steel
3.5" hard disk drive (Up to 4 hard disk drives can be installed.)
1 V [p-p]/75 Ω, x16 (1ch to 16ch) (BNC)
Vertical timing pulse multiplexed, HD616K: x8 (1ch to 8ch), HD716K: x16
1 V [p-p]/75 Ω (BNC)
HDMI, x2
1 V [p-p]/75 Ω, active loop-thru output, x16 (1ch to 16ch) (BNC)*
1 V [p-p]/75 Ω, x2 (BNC)
8
HDMI, x2*
1 V [p-p]/75 Ω, x1 (RCA pin)
–10 dBv, 10 kΩ, unbalanced, x4 (RCA pin)
–10 dBv, 10 kΩ, unbalanced x 1 (RCA pin)
–10 dBv, 600 Ω, unbalanced, x1 (RCA pin)
–10 dBv, 600 Ω, unbalanced, x1 (RCA pin)
x3
x1
3
8 to 16ch alarm output* , alarm reset input*
3
space warning output* , HDD trouble output*
3
put* , electricity failure recovery completion output*
sequence switching input/output*
2
tion input* , external recording mode switching*
2
1ch - 16ch alarm input* , 1 - 7ch alarm output*
7
RS485 (full duplex/half duplex* ), x2 (RJ-11)
RS485, x2 (RJ-11)
10BASE-T/100BASE-TX (RJ-45)
10BASE-T (RJ-45)
SDHC/SD memory cards applicable (miniSD cards and microSD cards not applica-
ble)
1
2
, emergency recording input*
3
, camera trouble output*
4
, time adjust input/output*
5 2
, alarm suspension input* , electricity failure detec-
2 6
, +5 V output* (25-pin D-sub)
3
(25-pin D-sub)
2
, available
3
, trouble out-
5
,
153