Mounting The Envoy - DAVIS Weather Envoy 6314 Installation Manual

H I
A R D W A R E N S T A L L A T I O N
Preparing the Envoy

Mounting the Envoy

You can install your Envoy on your desktop or on the wall next to your computer.
Note: Whenever you first install the Weather Envoy, place the antenna in a vertical position.
If necessary, you can adjust the angle for best reception after it's installed.
Use this procedure for a wall installation.
1. Find the template located on the next page.
2. Hold the template against the wall where you want to mount the Envoy, and
use a pencil to mark the location for the two mounting screws.
The screws should be 3.25" (82.5mm) apart and lined up vertically.
3. Drill the marked locations with a 3/32" or 7/64" ( 2.2 to 2.7 mm) drill bit.
4. Drive the two #6 x 1" (~ 3.5mm x 25mm) pan head self-threading screws into
the wall.
Leave at least a 1/8" (~ 3mm) space between the wall and the heads of the
screws.
5. Slide the keyholes on the back of the case over the two screw heads.
Wall Mounting the Weather Envoy
6
#6 x 1"
Pan-Head
Screws
3.25"
(82.55mm)
Drill 3/32"
or 7/64"
(~2.2 to 2.7mm)
Holes
Wall Mounting Template