Pr e pa r ing t h e E n voy
Perform the following procedures to prepare your Envoy for operation.
Install the Data Logger
Install the Batteries
Mount your Envoy
Make the Envoy Connections
Test using WeatherLink
Setup the Envoy using WeatherLink
Installing the Data Logger
CAUTION: The WeatherLink data logger must be installed before you install the
batteries!
1. Remove the three screws from the back of the
Envoy case.
2. Separate the case halves to expose
the data logger connector.
H
I
A R D W A R E
N S T A L L A T I O N
Preparing the Envoy
3