Table Of Contents; Preparing The Temp/Hum Station; Rotating The Mounting Bracket - DAVIS 6380 Wireless Temperature/Humidity Station Installation Manual

Installation Steps
For ease of installation, please follow the steps in the order presented.
• Preparing the Temp/Hum Station, page 2
• Rotating the Mounting Bracket, page 2
• Applying Power, page 3
• Setting the Transmitter ID, page 4
• Setting Console Station ID on the Console, page 5
• Setting the Console Station ID using WeatherLink, page 6
• Viewing Current Temperature and Humidity, page 6
• No Communication with Temp/Hum Station?, page 6
• Choosing a Location for the Temp/Hum Station, page 7
• Testing Transmission from Proposed Location, page 7
• Mounting the Temp/Hum Station, page 8
• A Note on Securing Cables, page 11
See "Maintenance" on page 10. For Technical Support, see "Contacting Davis
Instruments" on page 11.

Preparing the Temp/Hum Station

Rotating the Mounting Bracket

To facilitate packing and
shipping the Temp/Hum
Station, the mounting bracket
is installed upside down at
the factory. You will need to
rotate the mounting bracket
180° before you install the
station.
1. Place the Temp/Hum
Station on a level surface.
2. Loosen the three mount-
ing screws that hold the
mounting bracket and the
radiation shield together.
3. When the screws are com-
pletely loosened, lift the
mounting bracket away
from the radiation shield.
4. Rotate the mounting bracket and replace it on the radiation shield.
2
Remove
Mounting
Screws
Radiation
Shield
Assembly
Remove
and
Rotate
Mounting
Bracket
Installation Steps