Table of Contents
Advertisement
S
I
O F T W A R E
N S T A L L A T I O N A N D
Station Setup
4. To indicate whether you want to clear your archive memory, choose Yes or No.
If you choose Yes, the software clears your archive memory.
Set Archive Interval
You may choose to store data to the WeatherLink's archive memory at an interval
of 1, 5, 10, 15, 30, 60, or 120 minutes. This interval is known as the archive interval.
Look for information on archive memory and the effect that the archive interval
has on the amount of data which may be stored in the WeatherLink's archive
memory in the WeatherLink software Help.
Note: Setting the archive interval clears your archive memory. You should download data
before changing archive interval.
1. Choose Set Archive Interval from the Setup
menu.
The Set Archive Interval dialog box appears.
2. Select the desired archive interval and choose
OK.
The software warns you that it is about to clear
the archive memory.
3. To continue, choose OK.
The software sets the archive interval and
clears the archive memory.
Set Latitude and Longitude
To give you the best forecast, to calculate the correct times for sunset and sunrise
for your location, you must set the latitude and longitude in the console.
1. Choose Set Latitude/Longitude from the Setup menu.
2. Enter the following information:
Latitude
Enter the current latitude in degrees, minutes and seconds and indicate if
the position is in the Northern or Southern hemisphere.
Longitude
Enter the current longitude in degrees, minutes and seconds and indicate
if the position is in the East or West of the Prime Meridian.
3. Click on See Results to check the latitude and longitude settings that will
transfered to the Envoy. These are the same settings you entered, but rounded
to the nearest tenth of the degree.
4. When you are satisified with the settings, choose OK.
20
S
E T U P
Set Archive Interval
Advertisement
Table of Contents
