Appendix A: Sensiscan 2000
Control Switch Operation
Circuit corresponds to a specific I/O module installed in user configured
Sensiscan 2000.
The first 8 control switches of the LDM-32F will correspond to CPU switch
functions as shown below, if "8-Point Shift" is not selected.
With "8-Point Shift" selected, the first 8 control switches move to the 3rd LDM-
E32F and are assigned to Circuits 57 through 64 as shown below.
Note: It is assumed that Sensiscan 2000 systems with "8-Point Shift" selected will be 56
zones/points or less.
40
Switch
LDM-32F
Position
1
Acknowledge
2
Signal Silence
3
System Reset
4
Not Used
5
NAC #1
6
NAC #2
7
Municipal Tie
8
Alarm Relay
9
Not Used
10
Not Used
11
Not Used
12
Not Used
13
Not Used
14
Not Used
15
Not Used
16
Not Used
Table 10 Switch Control Functions
Control Switch Operation
-----
3rd LDM-E32F
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Acknowledge
Signal Silence
System Reset
Not Used
NAC #1
NAC #2
Municipal Tie
Alarm Relay
LDM-32F PN 50055:C 03/20/01