Fire-Lite LDM-32F Instruction Manual page 36

Appendix A: Sensiscan 2000
The following table defines the point assignments if incorporating the optional
modules available on the Sensiscan 2000.
Optional
Modules
IZ-8F
IZ-4F/IZE-4F
IC-4F/IC-4CCF
ICE-4F
CR-4F/CE-4F
TC-2F/TC-4F
1. Optional control switches are active only if all of these conditions are met:
a) '8-Point Shift' (DIP switch #4) is set to OFF.
b) Receive Only (DIP Switch #5) is set to OFF.
c) Switch Inhibit (DIP Switch #7) is set to OFF.
2. These Status LEDs are active only when the Sensiscan 2000 is programmed for Output
Status. Use green LEDs to indicate activation on controlled output circuits.
3. These control switches require that the Sensiscan 2000 be programmed for Output Control.
Table 5 Optional Modules Annunciator Point Assignment to LDMs
36
Alarm
(Red LED)
Alarm Status per Trouble Status per
Circuit Circuit
Alarm Status per Trouble Status per
Circuit Circuit
Indicates
Indicates Trouble
2
per Circuit
Activation
Indicates
Indicates Trouble
2
per Circuit
Activation
Indicates
Indicates Trouble
2
per Circuit
Activation
Indicates
Indicates Trouble
2
per Circuit
Activation
Lamp/LED Driver Operation
Trouble/Supv
Control Switches
(Yellow LED)
Not Used
Not Used
Momentarily Turns
On NAC Output
When Pressed
Momentarily Turns
On NAC Output
When Pressed
Relays
Remote Switch
Functions
LDM-32F PN 50055:C 03/20/01
1
3
3
3
3