Controls, Indicators And Operation; 1: Front Panel Slide Switches - Fire-Lite CMP-2401B Instruction Manual

Controls, Indicators and Operation

1.3 Controls, Indicators and Operation
1.3.1 Front Panel Slide Switches
CMP-2401B/CMP-2402B Control Switches
FIGURE 1-2:
SIGNAL INITIAT INITIAT
OUTPUT ZONE 1 - ZONE 2
- -
+ + +
All switches are illustrated in their normal position. The function of each switch is listed below.
System Reset
The function of this nonlatching switch is:
to reset the FACP and the smoke detectors provided the alarm condition has been cleared and 60 seconds has
1.
elapsed since the first alarm
LED test
2.
Signal Silence - Zone 1
Placing the switch in the Silence position will silence the Notification Appliance Circuit if 60 seconds has elapsed
since the first alarm. A trouble condition is indicated while the switch is in the Silence position. If an alarm
occurs on the silenced zone, the alarm LED will indicate the alarm condition and the alarm relay will transfer.
Signal Silence - Zone 2 (CMP-2402B only)
Placing the switch in the Silence position will silence the Notification Appliance Circuit if 60 seconds has elapsed
since the first alarm. A trouble condition is indicated while the switch is in the Silence position. If an alarm
occurs on the silenced zone, the alarm LED will indicate the alarm condition and the alarm relay will transfer.
Trouble Silence
This latching, two-position switch, will silence the piezo sounder. The trouble LED will continue to indicate a
trouble condition. An intermittent tone will sound when the trouble is cleared to indicate that this switch should
be returned to its normal position.
12
TB2
CUT IF 4X
OPTION
BOARD IS
PRESENT
R14
System Reset
SW1
Signal Silence Zone 1
SW2
Signal Silence Zone 2
SW3
(CMP-2402B only)
SW4 Trouble Silence
Document #50907 Rev.A1 12/03/02 P/N 50907:A1