Table of Contents
Advertisement
Appendix B: MS-9200
The figure below is an example of the connections used when setting the LDM
module for Alarm/Trouble mode.
J5
J6
The figure below illustrates pin usage of output connectors for system functions
in alarm/trouble mode.
Signals Silenced (Yellow)
System Trouble (Yellow)
System Alarm (Red)
Figure 31 System Functions to Output Connectors - 1
The figure below illustrates pin usage of output connectors for system functions
in alarm/trouble mode with 8-Point shift selected.
Signals Silenced (Yellow)
System Trouble (Yellow)
System Alarm (Red)
Figure 32 System Functions to Output Connectors - 2
44
J7
J8
Figure 30 Connections for Alarm/Trouble
System Status Indicators
J5
Note: Pins not marked are not used
System Status Indicators
J7
Note: Pins not marked are not used
Alarm - First 4 Zones or Points
Trouble - First 4 Zones or Points
Alarm - Second 4 Zones or Points
Trouble - Second 4 Zones or Points
Alarm - Third 4 Zones or Points
Trouble - Third 4 Zones or Points
Alarm - Fourth 4 Zones or Points
Trouble - Fourth 4 Zones or Points
Supervisory (Yellow)
AC Fail (Red)
J6
Supervisory (Yellow)
AC Fail (Red)
J8
LDM-32F PN 50055:C 03/20/01
Configuration
Advertisement
Table of Contents
