Burley Pre-2004 d’Lite User Manual page 10

Fasten with the bolt
and nut through
the clamp, but do
not tighten.
Adjust the brake by sliding backward or
forward as needed before tightening.
You will need to pull the brake handle
backward to move the brake to engaged
position (see next image).
10
Burley Walk 'n Roller Manual; models 2003 and earlier
Clamp the brake assembly onto the frame tube as
shown. The clamp should be oriented so that the bolt
runs underneath the main frame tubing.
With the brake in engaged position, handle back,
slide the brake forward until the post is just touching
the tire. Mark this position on the frame. Then rotate
the handle forward to disengage the brake, and
slide the brake forward about ¼ from the mark. Now
tighten the bolt.
Once tightened, engage the brake
to verify its function. The brake post
should push into the tire about ¼
inch, or half the diameter of the post.